JBL Speaker S36IIPM User Manual

T H A N K Y O U F O R C H O O S IN G J B L  
For more than 50 years, JBL has  
been involved in every aspect of  
music and film recording and  
reproduction, from live perform-  
ances to the recordings you play  
in your home, car or office.  
you expected – and that when you  
think about purchasing additional  
audio equipment for your home, car  
or office, you will once again  
choose JBL.  
ments, and helps us to better  
understand our customers and  
build products that meet their  
needs and expectations.  
JBL Consumer Products  
Please take a moment to register  
your product at our Web site,  
Were confident that the JBL loud-  
speakers you have chosen will  
provide every note of enjoyment that you posted on our latest advance-  
S T U D IO S E R IE S  
S 3 6 IIP M  
O W N E R ’S G U ID E  
 
Installation of Self-Adhesive  
Rubber Pads: If the speaker is to  
be placed on a surface (such as  
a table top or shelf) rather than  
wall-mounted, the enclosed self-  
adhesive rubber pads are to be  
attached to the bottom of the  
speaker cabinet in their desig-  
nated recessed locations. If the  
speaker is to be wall-mounted,  
then the four self-adhesive rubber  
pads should be attached to the  
back of the speaker, as shown in  
the bottom right diagram.  
pads are required, and they need  
to be installed on the back of the  
loudspeaker, near the lower edge,  
so that they are located between  
the back of the speaker and the  
mounting surface. Please see the  
enclosed installation template for  
more details.  
sories to these threads, as this  
might damage the speaker and  
dislodge the insert.  
PADS GO HERE  
NOTE: The threaded inserts on the  
bottom of the speakers are to be  
used only with JBL accessories  
that have been developed specifi-  
cally for the S36IIPM and that may  
become available at a future date.  
Do not attempt to install bolts or  
any non-JBL brackets or acces-  
For tabletop or shelf placement  
PLACE RUBBER PADS HERE  
KEYHOLES FOR  
MOUNTING HARDWARE  
When angle-mounting the  
S36IIPM, only two of the rubber  
For wall-mounting  
S P E A K E R C O N N E C T IO N S  
RIGHT  
LEFT  
sound systems, connecting all of  
the speakers in your system with  
CONNECTION TIPS  
+
+
the correct polarity remains  
equally important in order to pre-  
serve the proper ambience and  
directionality of the program  
material.  
+
+
Speaker Outputs  
European CE certification, these  
holes are blocked with plastic  
inserts at the point of manufacture.  
Use of banana-type connectors  
requires the removal of the inserts.  
Do not remove these inserts if  
you are using the product in an  
area covered by European CE  
certification.  
To use the binding-post speaker  
terminals, unscrew the collar until  
Speakers and electronics terminals  
the pass-through hole in the cen-  
have corresponding (+) and (–) ter-  
ter post is visible under the collar.  
minals. It is important to connect  
both speakers identically: (+) on the  
speaker to (+) on the amplifier and  
Insert the bare end of the wire  
through this hole; then screw the  
collar down until the connection  
(–) on the speaker to (–) on the  
is tight.  
amplifier. Wiring “out of phase”  
results in thin sound, weak bass  
and a poor stereo image. With the  
advent of multichannel surround  
The hole in the center of each col-  
lar is intended for use with banana-  
type connectors. To comply with  
T R O U B LE S H O O T IN G  
If there is no sound from any of the  
speakers:  
Check that receiver/amplifier is  
on and that a source is playing.  
Review proper operation of your  
receiver/amplifier.  
• Make sure all wires are con-  
nected. Make sure none of the  
speaker wires are frayed, cut or  
punctured, or touching each other.  
• If more than one pair of main  
Turn off all electronics and switch  
the speaker in question with one of  
the other speakers that is working  
correctly. Turn everything back on,  
and determine whether the prob-  
lem has followed the speaker, or  
has remained in the same channel.  
If the problem is in the same chan-  
nel, the source of the problem is  
most likely with your receiver or  
amplifier, and you should consult the  
owners manual for that product for  
further information. If the problem  
has followed the speaker, consult  
your dealer for further assistance  
or, if that is not possible, visit  
speakers is being used, check the  
minimum impedance requirements  
of your receiver/amplifier.  
If there is no sound coming from  
one speaker:  
Check the “Balance” control on  
your receiver/amplifier.  
Check all wires and connections  
between receiver/amplifier and  
speakers. Make sure no wires are  
touching other wires or terminals  
and creating a short circuit.  
• Make sure all wires are con-  
nected. Make sure none of the  
speaker wires are frayed, cut or  
punctured.  
• In Dolby* Digital or DTS® modes,  
make sure that the receiver/  
processor is configured so that the  
speaker in question is enabled.  
If the system plays at low volumes  
but shuts off as volume is  
increased:  
Check all wires and connections  
between receiver/amplifier and  
speakers.  
• Make sure all wires are con-  
nected. Make sure none of the  
speaker wires are frayed, cut or  
punctured, or touching each other.  
mation.  
 
S P E C IF IC A T IO N S  
S 3 6 IIP M  
Description: 3-Way 6" horizontal/vertical mirror-image wall-mount/bookshelf loudspeakers for indoor and  
outdoor use  
Maximum Recommended Amplifier Power:**150W  
Nominal Impedance: 8 Ohms  
Sensitivity (2.83V/1m): 90dB  
Frequency Response (–3dB): 60Hz – 20kHz  
Crossover Frequencies: 650Hz, 3000Hz  
High-Frequency Transducer: 1" Pure-titanium dome, with rubber surround, shielded; Elliptical Oblate  
Spheroidal™ (EOS) waveguide  
Midrange Transducer: 4" WeatherPlas™ (polymer-coated cellulose fiber) cone, rubber surround, shielded;  
Linear Field Proximity™ (LFP) bezel  
Low-Frequency Transducer: 6" WeatherPlas™ (polymer-coated cellulose fiber) cone, rubber surround,  
SFG, magnetic shorting rings, high-temp oversized Kapton® voice coil, HeatScape™ motor structure,  
cast-aluminum baskets, shielded  
Baffles: Low diffraction, IsoPower™  
Enclosure: Sealed  
Network: Straight-Line Signal Path™ (SSP)  
Terminals: All-metal, gold-plated, 5-way binding posts  
Dimensions (H x W x D): 10-1/4" x 14-5/8" x 5" (260mm x 371mm x 127mm)  
Declaration of Conformity  
Weight: 11 lb/5kg  
We, Harman Consumer International  
2, route de Tours  
72500 Chateau-du-Loir  
France  
declare in own responsibility that the loud-  
speakers described in this owner’s manual  
are in compliance with technical standards:  
* Dolby is a trademark of Dolby Laboratories.  
EN 50081-1:1992  
DTS is a registered trademark of Digital Theater Systems, Inc.  
EN 50082-1:1997  
**The maximum recommended amplifier power rating will ensure  
proper system headroom to allow for occasional peaks. We do not  
recommend sustained operation at these maximum power levels.  
Gary Mardell  
All features and specifications are subject to change without  
notice.  
Harman Consumer International  
Chateau-du-Loir, France 2/03  
P R O S O U N D  
O W N E R ’S G U ID E  
C O M ES H O M E ™  
P
R
O
D
U
C
T
L
I
N
E
:
S T U D I O S E R I E S  
JBL Consumer Products  
250 Crossways Park Drive, Woodbury, NY 11797  
8500 Balboa Boulevard, Northridge, CA 91329  
800.336.4JBL (4525) (USA only)  
M
O
D
E L :  
S 3 6 IIP M  
D E S IG N G O A L: Bring the thrill of live performance and movie sound to the  
home environment by calling on JBLs professional engineering leadership.  
T W E E T E R T Y P E : Pure-titanium dome with EOS waveguide  
© 2003 Harman International Industries, Incorporated  
W
O O F E R T Y P E : Cast-aluminum basket with HeatScape™ motor structure  
JBL is a registered trademark of  
Harman International Industries, Incorporated.  
C R O S O V E R N E T W O R K : Straight-Line Signal Path™ (SSP)  
S
E N C LO S U R E D E S IG N : Sealed  
Part No.406-000-05000  
P R O F E S  
S
IO N A L R E F E R E N C E : Studio Monitor  
 

Indesit Refrigerator RA 24I S User Manual
Jenn Air Gas Grill 209240 User Manual
John Deere Lawn Mower 5310 S User Manual
JVC Stereo System 0410YOMMDWCDT User Manual
Jwin Clock Radio JL CD815 User Manual
Kalorik Blender MFM 37992 User Manual
Kenwood Car Video System DDX3049 User Manual
Kenwood Two Way Radio TH D7E User Manual
Klipsch Speaker RT 10D User Manual
Konica Minolta All in One Printer A034012 User Manual