Jenn Air Charcoal Grill JGD8348CD User Manual

Triple Bay Conventional Gas Grill Cooktop  
PRODUCT MODEL NUMBERS  
JGD8348CD  
GAS REQUIREMENTS  
Gas supply: The installation of this appliance  
The maximum gas supply pressure for the  
Make the gas connection to the inlet of the  
appliance pressure regulator on this appliance  
with a 1/2" male pipe thread. Use an approved  
pipe joint compound resistant to the action of LP  
gas at pipe connections.  
must conform with local codes, or in the absence appliance pressure regulator supplied on this  
of local codes, with the latest edition of the  
National Fuel Gas Code ANSI Z223.1 USA or  
current CAN/CGA-B149 INSTALLATION CODE.  
appliance is 14" W.C. The test pressure for  
checking this appliance pressure regulator must  
be at least 6" W.C. for Natural Gas, and at least  
11" W.C. for LP. It is shipped from the factory set  
for Natural Gas at 5" W.C.  
This appliance was adjusted at the factory for use  
with natural gas. If, at any time, this appliance is  
to be used with a different type of gas, all of the  
conversion adjustments described in the  
installation instructions must be made by a  
qualified service technician before attempting to  
operate the cooktop on that gas.  
Electrical: See page 2.  
Install a manual shutoff valve in an accessible  
location in the gas line external to this appliance  
for the purpose of turning on or shutting off gas  
to the appliance.  
PRODUCT DIMENSIONS  
Dimension “A” - provide 2" min. (5.1 cm) cabinet clearance to motor for  
cooling purpose.  
Side Clearance: Grills installed near a side wall must allow a minimum  
clearance of 8" (20.3 cm).  
NOTE: Where possible, 6" (15.5 cm) is recommended for motor/blower  
service.  
Access must be provided to remove and empty grease container.  
This appliance is designed to always be vented outdoors.  
Page 1 of 3  
Because Whirlpool Corporation policy includes a continuous commitment to improve  
our products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. 8101P620-60  
09-25-08  
 
Triple Bay Conventional Gas Grill Cooktop  
PRODUCT MODEL NUMBERS  
JGD8348CD  
INSTALLATION OF CABINETRY OVER YOUR GRILL  
Minimum horizontal clearance between the edge of the appliance and  
combustible construction extending from the cooking surface to 18"  
(45.7 cm) above the cooking surface is:  
Avoid use of cabinets above cooktop for storage space to eliminate  
associated potential hazards such as reaching over open flames.  
Dotted lines indicate range hood construction.  
1-3/4" (4.5 cm) at rear  
8" (20.3 cm) at sides  
NOTE: This is not the  
* To eliminate the risk of burns or fire by  
reaching over heated surface units, cabinet  
storage space located above the surface units  
should be avoided. If cabinet storage is to be  
provided, the risk can be reduced by installing  
a range hood that projects horizontally a  
minimum of 5" (12.7 cm) beyond the bottom of  
the cabinets.  
recommended clearance,  
(4
but minimum allowable  
clearance.  
* A = 30" (76.2 cm)  
minimum vertical  
Cabinets Above Cooking Top  
clearance between  
MIN. CLEARANCE  
cooking surface  
Maximum depth of cabinets installed above cooking top is 13" (33 cm).  
and construction above the appliance.  
B = 13" (33.0 cm) maximum depth of cabinets installed above cooking  
top.  
MINIMUM SPACING REQUIREMENTS  
For installing a TripleBay Downdraft Cooktop in combination with another Downdraft Cooktop, the minimum spacing between adjacent units must be  
provided, as shown, for satisfactory performance.  
4-3/8"  
PROSTYLE  
COOKTOP  
ANY DOWNDRAFT  
COOKTOP  
(11.1 cm)  
(Single, Double or  
Triple Bay)  
18"  
(45.7 cm)  
PROSTYLE  
COOKTOP  
ANY  
DOUBLE BAY  
4-3/8"  
(11.1 cm)  
18"  
(45.7 cm)  
PROSTYLE  
COOKTOP  
ANY  
SINGLE BAY  
16-1/8"  
(41 cm)  
Page 3 of 3  
Because Whirlpool Corporation policy includes a continuous commitment to improve  
our products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. 8101P620-60  
09-25-08  
 

InFocus Projector in5130 User Manual
Insignia Stereo Receiver NS STR514 User Manual
Jackson Dishwasher AJ 100 User Manual
JVC Flat Panel Television 1EMN24939 User Manual
JVC Flat Panel Television 0109TSH II IM User Manual
JVC Projector DLA L20 User Manual
JVC VCR HR DD445EK User Manual
Kenwood TV DVD Combo KVT 647DVD User Manual
Kicker Speaker 07 WX 10000 1 User Manual
Kodak Digital Camera 8749400 User Manual