Kenwood Marine Radio KCA RC50MR User Manual

KCA-RC50MR  
Marine Remote Control  
Installation Instructions  
Mounting The Remote Control:  
1. Select a mounting location that is flat and 1/2” thick or less.  
2. Using the supplied rubber gasket as a template, drill the mounting holes and a hole for the wiring  
at the desired locations.  
3. Mount the remote control according to the diagram in FIG. 1 using supplied hardware.  
4. Connect the electrical wiring for power, illumination, and ground as shown in FIG. 1.  
Connect supplied data line to remote, route to the radio and connect to the connector on the  
rear of the radio as shown in FIG. 2.  
2 AMP FUSE  
RED  
+ 12V switched/ignition  
YELLOW Illumination (connect to instrument lighting)  
BLACK:  
BLUE  
ground  
Data line (connect to radio)  
NUT  
LOCK WASHER  
WASHER  
MOUNTING SURFACE  
GASKET  
REMOTE  
FIG. 1  
Data Line Connection  
Point:  
Note, The rear view of radio and location  
of connection point will vary dependent  
on radio model.  
FIG. 2  
 

Infantino Baby Carrier 201 542 User Manual
Invacare Air Compressor IRC607 User Manual
IOGear Network Card GPS702e3W6 User Manual
JBL Universal Remote On Stage II Remote User Manual
Jenn Air Dishwasher JDB1100AWB User Manual
JVC Car Speaker CS V6942 User Manual
Kambrook Blender KB600 User Manual
Kawasaki Motor Scooter KLR250 User Manual
Kenwood Marine Radio TM 251A User Manual
KitchenAid Blender 4KFPW760OB0 User Manual