Kenwood Speaker K ES01 User Manual

System connections  
SEPARATE CUSTOM FIT SPEAKER  
Connection example 1  
Tweeter connection from center unit. (Tweeter is installed on the dashboard.)  
K-ES01  
Center unit  
INSTRUCTION MANUAL  
Black/Gray  
6Connection cord (for tweeter)  
Black/Gray  
KENWOOD CORPORATION  
B54-1210-20 (FHP)  
Tweeter  
Thank you for purchasing this product.  
Speaker output  
Black  
Black/Gray  
Please read this instruction manual thoroughly before installing speakers, and  
install speakers correctly.  
Black  
8Erectro-tap (for woofer)  
Refer to "Woofer connections" in this instruction manual.  
Red  
Black/Gray  
Black/Gray  
Phillips screwdriver, Flat-head screwdriver, Clip driver, Pliers, Nippers, Wrench,  
Tools required for installation  
Electric hand drill and bits, Cutting knife, Electrical tape, Scissors, Felt-tip pen  
Black  
Black  
Safety caution  
Woofer  
Be sure to observe the warning and caution provided below as they are critical for your safety.  
The meanings of the symbols are as follows.  
Black  
~Connection cord  
Black  
(for woofer)  
Vehicle connector  
These indicate what must not be done.  
(Inhibition marks)  
This indicates what must be done.  
(Imperative mark)  
The high path filter for a tweeter is built in the main part of a tweeter.  
Installation cautions  
Connection example 2  
Tweeter connection from woofer. (Tweeter is installed on the door panel.)  
If the product is handled erroneously by ignoring the instruction of this mark,  
fatal hazard or serious injury on human body may result.  
WARNING  
Work depending to instruction manual.  
Remove battery connection before work.  
Use proper tools for the processing  
objects.  
Wrap cords with protective tape.  
When installing or wiring the product,  
be sure to follow strictly the instruction  
and installation manuals of the product.  
(If the instructions are not observed  
strictly, the product may be displaced  
and hit you during braking and there  
may also be a risk of electric shock or  
fire hazard.)  
Before installing or wiring anything, be  
sure to remove the cable from the nega-  
tive terminal of the battery.  
The cords near metallic parts of the  
vehicle should be protected against  
sharp edge of the metallic parts by  
wrapping insulating tape around them.  
(If a cord is damaged, electric shock or  
short-circuiting* as well as fire hazard  
may result.)  
When tightening a bolt or nut, always be  
sure to use the tool matching its size. If  
the securing torque of a part is speci-  
fied, be sure to secure it with the speci-  
fied force.  
Cut  
(Otherwise  
a
shorting accident* may  
6Connection cord (for tweeter)  
occur, which could result in fire acci-  
dent.)  
(Otherwise the bolt or nut may be dam-  
aged or detached during use.)  
Remove negative terminal.  
Center unit  
Black/Gray  
Please read thoroughly.  
6Connection cord which is cut  
(for tweeter)  
Be careful not to damage the tank and  
electric wiring.  
Do not cut insulation tube in the middle Do not open the back and top covers of  
Use a fuse with the specified rating.  
of a power cord.  
the product or modify it.  
When the fuse is blown, first ensure that  
there is no short-circuiting* between the  
wired cords, then replace with a new  
fuse with the capacity (Ampere value)  
specified on the fuse box.  
Tweeter  
Red  
In case the product is installed by mak-  
ing holes on the vehicle chassis, be  
careful never to damage the gasoline  
tank, piping, electric wiring or other  
parts of the vehicle.  
Do not use power cord for other prod-  
ucts by cutting insulation tube in the  
middle of a power cord.  
(This may lead to fire hazard or other  
accident.)  
• For inspection and servicing, consult  
your dealer or nearest KENWOOD ser-  
vice agent or distributor.  
8Erectro-tap (for woofer)  
Black/Gray  
Black  
Black/Gray  
Refer to "Woofer connections" in this instruction manual.  
(Otherwise  
a
shorting accident* may  
(Using other fuse than specified may  
lead to fire hazard.)  
occur, which could result in fire acci-  
dent.)  
(Otherwise fire hazard may result.)  
• Servicing by the user may lead to fire  
hazard or other accidents.  
Please check the spec.  
Black/Gray  
• For fuse replacement, refer to the  
owner's manual of your vehicle.  
Black  
If the product is handled erroneously  
by ignoring the instruction of this  
mark, injury on human body, or dam-  
age of product may result.  
Use provided parts for installation.  
Inspect the vehicle after installation.  
Black  
Black  
Be sure to install a product using pro-  
vided parts. When parts other than the  
provided ones are used, a product may  
fall off and hit the passenger while driv-  
ing, causing injury or product breakage.  
After installation of the product, be sure  
to check that the brake lamps, head  
lamps, direction indicators, windshield  
wipers, power window, etc. of the vehi-  
cle function normally.  
Woofer  
CAUTION  
~Connection cord (for woofer)  
Connection cord  
of vehicle  
Black  
Do not pull the cord.  
(If any of the vehicle functions are dam-  
aged due to incorrect wiring , etc., traf-  
fic accident may result. )  
Vehicle connector  
When you remove the connector, please  
remove and lock it with the connector  
main part, without pulling the cord.  
Otherwise disconnection of a cord and  
poor contact may result.  
The high path filter for a tweeter is built in the main part of a tweeter.  
If the tweeter level is too high.  
* Short-circuiting and shorting accident  
Short-circuiting refers to the direct connection between the positive and negative poles of electricity. This may occur when a stripped cord (electric wiring) comes in  
contact with another cord or metallic part of vehicle. Short-circuiting may produce spark, which may be caught by surrounding objects and result in fire hazard.  
Connection example 3  
Tweeter connection from center unit. (Tweeter is installed on the dashboard.)  
7Sound Level Adjuster  
(for tweeter)  
Black/Gray  
Black/Gray  
Black/Gray  
Black/Gray  
Cautions on use  
WARNING  
Tweeter  
Operate the car audio after stopping  
the vehicle.  
Do not use loud volume.  
Do not continue sound output at an  
abnormal level.  
Do not open the back and top covers of  
the product or modify it.  
Center unit  
Black  
Black  
During driving, do not turn the listening vol-  
ume too high at which you cannot hear the  
sound outside the vehicle.  
The car audio system should be operated after  
having stopped the vehicle in a safe place.  
(Operating it while driving a vehicle may lead  
to traffic accident.)  
Do not use the speakers for a long period at a  
high volume level at which the sound is dis-  
torted.  
(This may lead to fire hazard or other acci-  
dent.)  
6Connection cord (for tweeter)  
(You may be unable to notice what is happen-  
ing outside the vehicle, and a traffic accident  
may result. )  
For the inspection and servicing, consult your  
dealer or nearest KENWOOD service agent or  
distributor.  
Servicing by the user may lead to fire hazard  
and other accidents.  
(The system may be overheated and fire haz-  
ard may result. )  
Black/Gray  
Speaker output  
Black/Gray  
Black  
8Erectro-tap (for woofer)  
Red  
Immediately stop operation in case of abnormality.  
Refer to "Woofer connections" in this instruction manual.  
Should any of the following abnormal phenom-  
ena is observed, immediately stop the use and  
operation of the product.  
The product starts smoking.  
CAUTION  
Abnormal noise or odor is produced.  
(If the use of the product is continued, fire haz-  
ard or other accident may result.)  
In this case, immediately switch the power off,  
check safety and consult your dealer or nearest  
KENWOOD service agent or distributor.  
Black/Gray  
Black/Gray  
No sound output.  
Do not use the product for other purpose  
than car use.  
Water is spilt on the product.  
A foreign object such as metal or a piece of  
paper gets inside the product.  
This product has been designed for installation and  
operation in a vehicle. Do not use it for other pur-  
pose.  
(Otherwise imperfect installation may cause the  
product to drop and cause injury.)  
Black  
Black  
Woofer  
Black  
~Connection cord  
(for woofer)  
Black  
Vehicle connector  
• Please install depending to this instruction manual. Please keep it carefully after fin-  
ishing reading this. It is better to keep this manual together with the owner's manual  
of your vehicle.  
• For inquiries on installation, please consult your dealer or nearest service agent.  
• Refer to guidance on attached sheet for inquiry about the product to our company.  
If the tweeter level is too high.  
Tweeter connection from woofer. (Tweeter is installed on the door panel.)  
Connection example 4  
7Sound Level Adjuster  
(for tweeter)  
Black/Gray  
Black/Gray  
Black/Gray  
Black/Gray  
Caution  
1. When installing in some types of a car, it is necessary to remove the seat belt. It is  
necessary to mount the bolt which fixes a seat belt by the specified force. For  
inquiries on torque, please consult your dealer or your car shop.  
2. When installing in some types of a car, you have to install using an installation kit.  
For inquiries, please consult your dealer.  
3. Depending on the year or grade of a car, some vehicles may have changed parts.  
For inquiries, please consult your dealer.  
Tweeter  
Black  
Black  
Center unit  
6Connection cord which is cut  
(for tweeter)  
Refer to Connection exsample 2.  
8Erectro-tap (for woofer)  
Black/Gray  
Black/Gray  
Refer to "Woofer connections" in this instruction manual.  
Red  
About bolting torque  
Black/Gray  
"The power to twist something" is called "torque."  
Two persons grip each end of one bat, and twist in opposite direction, respectively. In this case, the person with the  
thick bat side is more advantageous.  
Black  
Black  
Black  
Thus, even if using the same force, turning something with a large radius will have larger twisting strength, or torque.  
Woofer  
~Connection cord (for woofer)  
Connection cord  
of vehicle  
0.1m  
1m  
Black  
[Bolting torque of a screw] ; The power in which an adult tightens a  
Vehicle connector  
screw normally using an ordinary screwdriver is 1-2N·m (0.1-0.2kgf·m).  
[Bolting torque of a bolt] ; The torque when tightening a bolt by 25kg  
power using a wrench is 49N·m (5kgf·m).  
Caution  
• The terminal which is not used should be protected by electrical tape for shorting accident prevention.  
1kg  
• Be careful of the polarity of plus/minus and connect depending to the connection example.  
10kg  
Both are the same torque, 9.8N·m (1kgf·m).  
 

Indesit Cooktop KD3G11S G User Manual
Ingersoll Rand Power Screwdriver ELM0107N User Manual
Jenn Air Cooktop JGC9430 User Manual
JVC Camcorder NAB 2007 User Manual
JVC CD Player KD AR560 User Manual
JVC CD Player KD DB711 User Manual
JVC DVD Player HR XVC16BU User Manual
JVC Portable CD Player 0404SKMCREORI User Manual
Jwin Clock Radio JL CD815 User Manual
Kenmore Microwave Oven 72180822 User Manual